Skip to content

Hinges

Butt, ball-bearing, radius, flap, lift-off, parliament and spring hinges in SS 202 and SS 304, pin or welded.

Length 60 to 150 mm

Matt stainless steel welded flap hinge, open, with the inner leaf cut-out visible

Flap hinges

SS 202 / SS 304

Length 100 to 125 mm

Made to be looked at closely

Below is a 5 in two-bearing welded butt hinge from our range, marked up like a drawing. Each lettered detail is something you can check on the hinge in your hand.

UL Listed
4 × 3 × 3 and 5 × 3 × 3 ball-bearing hinges
Finishes
Seven standard; others to order
Grades
SS 202, SS 304, SS 316
Construction
Pin or welded, 2 or 4 bearings
5 in two-bearing welded butt hinge, matt stainless steel. Lettered circles mark the details shown alongside.
  1. Macro view of the welded end of a matt stainless steel hinge barrel, with no visible pin head

    Detail A: Welded head

    On welded hinges the pin is fixed at both ends of the barrel. It cannot work loose, and the leaves cannot be lifted apart, so the door stays on its hinges.

  2. Macro view of a knuckle joint on a matt stainless steel hinge, with an even gap along the barrel

    Detail B: Even leaf gap

    The knuckle joints run tight and even along the barrel, so the leaves close parallel and the door hangs true, without binding at the frame.

  3. Macro view of a ball-bearing ring between two knuckles on a matt stainless steel hinge

    Detail C: Smooth movement

    Ball bearings sit between the knuckles and carry the weight of the door, so the leaves turn on steel balls instead of grinding face to face. Two bearings for standard doors, four for heavier ones.

  4. Macro view of a countersunk screw hole in a matt stainless steel hinge leaf

    Detail D: Countersunk holes

    Screw holes are countersunk, so the screw head sits level with the leaf. The hinge closes fully, and nothing stands proud to catch the frame.

  5. Macro view of the UL Listed door hinges stamp, R41718, 3 hrs fire rated, in a matt stainless steel hinge leaf

    Detail E: UL Listed

    Our 4 × 3 × 3 and 5 × 3 × 3 ball-bearing hinges are UL Listed to UL 10C, the standard for fire tests of door assemblies. The mark is stamped into the leaf, where it stays for the life of the hinge.